Raveon FireLine Ethernet Spécifications télécharger pdf (Page 39)

Company Confidential

Raveon Technologies Corp.

7 = Transmit CW

8 = Transmit 1010101…

Max Packet Size – Set the maximum number of bytes in an

over-the-air packet.

1 - 512

240

Read DC input Voltage– Returns the DC input voltage

reading, in mV (12500 = 12.5VDC input).

None

none

Firmware Version – Returns firmware version currently

loaded on the module.

Read Only, 3

characters

none

Show or Configure the Repeat Table – Set the addresses

that this unit will store-and-forward data to/from. n = 1, 2, 3, or

4 designating the entry in the table to show or edit..

Four parameters

aaaa bbbb cccc dddd where

aaaa=Source Address

bbbb = S.A. Mask

cccc = Destination Address

dddd = D.A. Mask

Enable/Disable Store and Forward Repeating – 0=disabled,

1 – enabled.

0 or 1 0 (Off)

Restore Factory – Restore the factory default values. This

command will not erase the calibration values. After this

command executes, the modem will still be in the CONFIG

mode.

none

** indicates values that are calibrated in the factory and are unit-specific. If the “Radio

Type” is changed, these will need to be re-calibrated.

8.9. Default Frequencies

Channel 1 464.500 MHz

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Pas de commentaire

Raveon FireLine Ethernet Spécifications Page 39