Raveon RV-M7 Spécifications Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 67
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
RV-M7 Technical Manual
28
5 = TX all 1s
6 = Test Points ON
7 = Transmit CW
8 = Transmit 1010101…
ATTE
Read product temperature Read the internal temperature
of the unit’s circuit board in degrees Celsius.
-40 to +99
-
ATTT
Max Packet Size Set the maximum number of bytes in an
over-the-air packet.
1 - 512
80
ATV0
Numeric Response code Configure the unit to send 0, 1 and
2, response codes.
-
-
ATV1
Verbose Response code Configure the unit to send OK,
ERROR, and CONNECT response codes. This is the default
value.
1
(Verbose messages)
V1
ATVB
Read DC input Voltage Returns the DC input voltage
reading, in mV (12500 = 12.5VDC input).
None
none
ATVR
Firmware Version Returns firmware version currently
loaded on the module.
Read Only, 3
characters
none
ATXn
Show or Configure the Repeat Table Set the addresses
that this unit will store-and-forward data to/from. n = 1, 2, 3, or
4 designating the entry in the table to show or edit..
Four parameters
aaaa bbbb cccc dddd where
aaaa=Source Address
bbbb = S.A. Mask
cccc = Destination Address
dddd = D.A. Mask
ATXR
Enable/Disable Store and Forward Repeating 0=disabled,
1 enabled.
0 or 1
0 (Off)
ATXT
Read/set repeater delay Read or set the repeater delay.
This is the time between receiving a data packet, and the time
the repeater will re-send it.
AT&F
Restore Factory Restore the factory default values. This
command will not erase the calibration values. After this
command executes, the modem will still be in the CONFIG
mode.
none
AT&F%
RN
Go off-line and enter command mode If the string
AT&F%RN is sent to the modem when it is on-line and the BT
and AT timing is meet, the modem will go off-line and go into
the command mode. C22 or higher firmware. See technical
bulletin AN163 for more information about this command.
AT&F%RN
none
** indicates values that are calibrated in the factory and are unit-specific. If the “Radio
Type” is changed, these will need to be re-calibrated.
5.10 Other non-AT commands
BAND
Read the Band Reads the frequency band of the radio.
First parameter is the text version (UA, UC, VB, …),
second parameter is the lower limit, and the third
parameter is the upper limit in MHz. Use to read the band
None
-
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 66 67

Commentaires sur ces manuels

Pas de commentaire